Description

Install: 1. Disconnect the power 2. Use a screwdriver to remove the screws on the bottom plate of the grill and take off the bottom plate 3. Find the wiring harness, disconnect all connections, and remove the old digital thermostat controller board with the help of a tool 4. Connect the probe wire to the location of the blue box on the new controller board 5.. Insert the new plugs into the connectors again in the original order, then reattach the controller to the grill 6. Install the bottom plate and use it normally. Specification Material: The circuit board adopts FR-4 Input: AC 120V 60Hz(PIN1-4) Output: AC 7.5V 200mA(PIN5~6) Meaning of possible error codes after connection ERR: This indicates a possible disconnection of the furnace temperature probe. Please check if it is properly connected. ERL: This code signifies a failed ignition. In such cases, we suggest inspecting the ignition rod for any issues. ERH: If this code appears, it means that the temperature has exceeded the recommended level, causing the controller to automatically shut down and stop feeding. You can open the cover to dissipate heat and restart the machine later. Notes 1.Please learn about this product in detail before purchasing to see if it your oven model. 2.After the error is displayed, please check the meaning of the garbled code listed in the product description. If it is not included, please check the oven motor, fan, ignition rod, etc. 3.It is recommended to find a professional to install it for specific installation and use. 4.The interface should be plugged in tightly during installation. If the interface is not plugged in tightly, it will loosen later, causing a short circuit or other faults. 5.When the temperature drops to about 180, add the auger to the pot. It will take about 5 minutes to start producing more smoke. models: Fit for Z grills pellet ,wood pellet grill and BBQ digital thermostat control panel parts LCD Display: The control panel with LCD display, clear and obvious, it can display the temperature clearly and accurately, allowing you to enjoy the fun of barbecue easily and happily The digital thermostat wood pellet Z grill controller board has smoke mode and temperature modes from 225 ℉ to 450 ℉ (High) Installation: Professional installation is recommended for specific installation and use. The purple wire on the display controller is used to connect the ignition rod. The black wire is used to connect the power supply. The red wire is used to connect the motor. The orange wire is used to connect the fan motor. * Original box or packaging is not included.